Step 1

Using the template provided in the package, find a good location for your CS1. Make sure the cord is long enough for the closest ceiling lamp outlet. Mark the two holes in the template and drill approximately 6 cm deep using an 8 mm diameter drill bit.

Please remember to verify how deep you are allowed to drill in your ceiling in order to avoid damaging pipes, ventilation or electrical components etc.

Please check your ceiling material before the install. Use appropriate plugs/expanders that can support the recommended minimum weight of 20 kg.

Step 2

Push the 2 concrete anchors into the holes, use a hammer if necessary.

Using a T25 Torx bit, screw in the screw pins until only the threads are exposed.

Step 3

Remove the speaker cover and remove the speaker driver using a Philips head screwdriver (push in 3 cm and twist 180 degrees counter clockwise). Disconnect the attached speaker power cable and put it back into the CS1 cabinet.

Attach the CS1 to the ceiling using the winged nuts. Since the CS1 is heavy, you might want to ask a friend for help.

When properly attached, the CS1 should not wiggle when moved. If the CS1 is not attached firmly against the ceiling you need to tighten the winged nuts more. There will be a ~3mm gap between the ceiling and the CS1 because of the rubber spacers.

Step 4

Attach the speaker power cable to the speaker driver and attach the speaker driver to the CS1 cabinet. Twist the 4 flaps to lock the speaker driver in place.

Plug in the main power cable into the lamp socket and switch on the power.

Step 5

Attach the speaker power cable to the speaker driver and attach the speaker driver to the CS1 cabinet. Twist the 4 flaps to lock the speaker driver in place.

Plug in the main power cable into the lamp socket and switch on the power.

The next steps should be done in the apps PLEJD and 4STREAM

Step 6

Open the PLEJD app in your iOS or Android device, make sure that Bluetooth and WiFi is enabled.